Wednesday, August 28, 2013

DIY Reusable To Do List


Picture frame
Patterned Paper
Things To Decorate With
( Washi tape, Stamps, Markers, ect..)

My picture frame came with a insert. So i'm going to glue my paper to this. If yours doesn't come with
this then you just going to have to cut your paper to the correct size.

Cover your insert with paper and I taped the edges on the back side.

My paper didn't cover the whole thing so I cut a strip and put it up against the rest of the paper
and did the same as on the other piece.

Now its time to decorate!!

This is what I did. The To Do is taped so it stays down, and the mustache is a stamp that I colored 
in with marker to make it darker.

Here is the finished project. You can write on the glass with dry erase marker so it's like a 
white board. You can make it smaller and put in your locker.

Tuesday, April 30, 2013

DIY Rings


1 Big Bead
A couple of small ones

Place the bead(s) on the wire.
You may want to curl one end so they don't slip off.

Make a loop with one end of the wire.

Go around the last bead on the open side so all the beads stay in place.
Measure it around your finger. Where the wire reaches the loop make a hook and then place the hook inside the loop and close it .
Your ring is complete.

Wednesday, February 6, 2013

No Sew Blanket

                                                                   Things needed:
               Pieces of Polar Flecce


                 Cut the pieces so it covers your doll with lots extra.

                                                       Then cut the edge into strips.

                 Then knot the two pieces together. 

                              You're Done!

Tuesday, January 8, 2013

Holder for Your Reading Device

Felt(Gray,Yellow,and Black)
Sewing Machine

Cut out these peices.
The rectangle is 2 3/4 by 2 inches.

Sew the face like this.

Sew velcro on top of one of the rectangles.

Sew the face to the other rectangle so it is like a flap.

Sew the rectangle with the velcro on
the other rectangle so there is a pocket on the top.

You are done!

Monday, January 7, 2013

HTM a Reading Device for 18'' doll

Things Needed
Tissue paper
any Paper with words
Tape (optional)

                                 Cut a 2 1/2'' by2'' piece of cardboard 
                               and cover it with the writing paper.
                                                Make sure the words are going the right way!

Cover backside with tissue paper and cut with a little extra on the edge.

Fold up edges and glue.
Tada you are done!

If using tape just tape the edges and back 
after adding the words.